Users Guide
33 | Configuring W-AirWave Dell Networking W-AirWave 8.2.4 | User Guide
Setting Default Description
Allow WMS Offload
configuration in
monitor-only mode
No When Yes is selected, you can enable the ArubaOS WMS offload
feature on the Groups > Basic page for WLAN switches in Monitor
Only mode. Enabling WMS offload does not cause a controller to
reboot. This option is supported only for Aruba and Dell Networking
W-Series devices.
Allow disconnecting
users while in
monitor-only mode
No Sets whether you can deauthenticate a user for a device in monitor-
only mode. If set to No, the Deauthenticate Client button for in a
Clients > Client Detail page is enabled only for Managed devices.
Use Global Dell
Configuration
No Enables Dell Networking W configuration profile settings to be
globally configured and then assigned to device groups. If disabled,
settings can be defined entirely within Groups > Controller
Configinstead of globally.
NOTE: Changing this setting may require importing configuration on
your devices. When an existing Dell Networking W configuration
setup is to be converted from global to group, follow these steps:
1. Set all the devices to Monitor Only mode before setting the flag.
2. Each device Group will need to have an import performed from
the Audit page of a controller in the AMP group.
3. All of the thin APs need to have their settings imported after the
device group settings have finished importing.
4. If the devices were set to Monitor Only mode, set them back to
Managed mode.
Table 8: AMP Setup > General > Device Configuration Section Fields and Default Values (Continued)
AMP Features
Locate the AMPī¢Features section and adjust settings to enable or disable VisualRF and RAPIDS. Table 9
describes these settings and default values.
Setting Default Description
Display VisualRF No Enable or disable the VisualRF navigation tab.
Display RAPIDS No Enable or disable the RAPIDS navigation tab.
Hide setup pages
from non-admin
users
Yes Restrict access to following pages to users with the AMP Administration
role only:
l VisualRF > Setup
l AMP Setup > NMS
l RAPIDS > Score Override
l RAPIDS > Rules
l RAPIDS > Setup
l System > Triggers
Allow role based
report visibility
Yes Enable or disable role-based reporting in AMP. When disabled, reports can
only be generated with by-subject visibility.
Table 9: AMP Setup Setup > General > AMP Features Fields and Default Values
External Logging Settings
Locate the External Logging section and adjust settings to send audit and system events to an external syslog
server. Table 10 describes these settings and default values. You can also send a test message using the Send
Test Message button after enabling any of the logging options.