Users Guide

37 | Configuring W-AirWave Dell Networking W-AirWave 8.2.4 | User Guide
Setting Default Description
Enable FTP Server No Enables or disables the FTP server on W-AirWave. The FTP server is only
used to manage Aruba AirMesh and Cisco Aironet 4800 APs. Best
practice is to disable the FTP server if you do not have any supported
devices in the network.
Enable RTLS
Collector
No Enables or disables the RTLS Collector, which is used to allow
ArubaOScontrollers to send signed and encrypted RTLS (real time
locating system) packets to VisualRF; in other words, W-AirWave becomes
the acting RTLS server. The RTLS server IP address must be configured on
each controller. This function is used for VisualRF to improve location
accuracy and to locate chirping asset tags. This function is supported only
for Dell Networking W-Series, Alcatel-Lucent, and Aruba Networks
devices.
If Yes is specified, the following additional fields appear. These
configuration settings should match the settings configured on the
controller:
l RTLS Port—Specify the port for the W-AirWave RTLS server.
l RTLS Username—Enter the user name used by the controller to
decode RTLS messages.
l RTLS Password—Enter the RTLS server password that matches the
controller’s value.
l Confirm RTLS Password—Re-enter the RTLS server password.
Use embedded
Mail Server/ Mail
Relay Server
Yes Enables or disables the embedded mail server that is included with W-
AirWave. If Yes is specified, then enter information for an optional mail
relay server.
This field supports a Send Test Email button for testing server
functionality. Clicking this button prompts you with To and From fields in
which you must enter valid email addresses.
Process user
roaming traps from
Cisco WLC
Yes Whether W-AirWave should parse client association and authentication
traps from Cisco WLC controllers to give real time information on users
connected to the wireless network.
Enable AMON data
collection
Yes Allows W-AirWave to collect enhanced data from Dell Networking W
devices on certain firmware versions. See the Dell Networking W-AirWave
Best Practices Guide on dell.com/support/manuals for more details
NOTE: When enabling AMON, auditing should be set to daily and have
been successful at least once to allow W-AirWave to calculate the proper
BSSIDs per radio. If these BSSIDs do not exist, clients are dropped
because they do not have any corresponding BSSIDs in the W-AirWave
database. Auditing should be set to daily because the BSSIDs are kept in
cache memory and cleared every 24 hours.
Enable Clarity Data
Collection
Yes Allows W-AirWave to collect enhanced Clarity Monitoring data from Dell
Networking W devices running ArubaOS 6.4.3 and later versions
Enable AppRF Data
Collection
Yes If AMON is enabled for a controller, you can enable this flag to instruct W-
AirWave to collect AppRF data from the controller. If this is enabled, then
the Home > AppRF page will display.
AppRF Storage
Allocated (Greater
than or equal to 2
GB)
50 If AppRF Data Collection is enabled, specify the amount of storage to
allocate.
Table 13: AMP Setup > General > Additional AMP Services Fields and Default Values