Users Guide

Setting Default Description
Enable UCC Data
Collection
Yes Enables controllers to send UCC data to Dell Networking W-AirWave. For
this feature to work, Dell Networking W-AirWave must be a management
server on the controller, the AMON port is set up for UDP port 8211, and
the controller profile has UCC monitoring enabled.
Enable UCC Calls
Stitching
(Heuristics)
Yes Enables caller-to-callee call stitching for non-SDN deployments. You
should turn off this option for NATand BOC deployments.
Prefer AMONvs
SNMP Polling
SNMP
Polling
Prefer AMON is a configuration setting which causes W-AirWave to use
an AMON feed to obtain client monitoring information from a controller
rather than polling it via SNMP. When you enable this setting, values such
as AP lists and rogue AP lists are still polled via SNMP, but the bulk of
client monitoring information is delivered via AMON.
Before enabling the Prefer AMON setting, please note the following:
l Auditing needs to have been successful at least once to allow W-
AirWave to calculate the proper BSSIDs per radio.
l When Prefer AMON is enabled, the controller must be configured to
send AMON to W-AirWave.
l The network path from the controller to the W-AirWave server must
allow traffic on UDP port 8211.
l The controller routinely sends AMON in large UDP packets, (up to 30K
bytes). Before enabling this setting, ensure the network path from the
controller to W-AirWave can pass such large packets intact.
l This setting should only be used in a network environment with low
levels of UDPpacket loss, as the loss of a single Ethernet frame will
potentially result in the loss of up to 30K bytes worth of data.
Enable Syslog and
SNMP Trap
Collection
Yes This option specifies whether traps used to detect roaming events, auth
failures, AP up/down status, and IDS events will still be collected if they
are sent by managed devices.
Require SSH host
key verification
No
This setting reserved for future use.
Validate PAPI key No Security improvements in W-AirWave 8.2.1 and later releases allow you to
specify a custom PAPIkey and require PAPI key validation. If you select the
Yes option, you are prompted to enter a custom PAPI key
Table 13: AMP Setup > General > Additional AMP Services Fields and Default Values (Continued)
Performance Settings
Locate the Performance section. Performance tuning is unlikely to be necessary for many W-AirWave
deployments, and likely provides the most improvements for customers with extremely large Pro or Enterprise
installations. Please contact Dell support at dell.com/support if you think you might need to change any of
these settings. Table 14 describes the settings and default values of this section.
Dell Networking W-AirWave 8.2.4 | User Guide Configuring W-AirWave | 38