Users Guide

41 | Configuring W-AirWave Dell Networking W-AirWave 8.2.4 | User Guide
Setting Default Description
IPv4 Address None Sets the IPv4 address of the W-AirWave network interface.
NOTE: This address must be a static IP address.
Hostname None Sets the DNS name assigned to the W-AirWave server.
Subnet Mask None Sets the subnet mask for the primary network interface.
IPv4 Gateway None Sets the default gateway for the network interface.
IPv6 Enabled No By selecting Yes, you can enter an optional IPv6 address and gateway
address.
IPv6 Address None Sets the IPv6 address of the W-AirWave network interface.
IPv6 Gateway None Sets the default gateway for the network interface.
Primary DNS IP None Sets the primary DNS IP address for the network interface.
Secondary DNS IP None Sets the secondary DNS IP address for the network interface.
Table 15: Primary Network Interface Fields and Default Values
Secondary Network Interface Settings
Locate the Secondary Network Interface section. The information in this section should match what you
defined during initial network configuration and should not require changes. Table 16 describes the settings and
default values.
Setting Default Description
Enabled No Select Yes to enable a secondary network interface. You will be
prompted to define the IP address and subnet mask.
IP Address None Specify the IP address of the W-AirWave secondary network.
NOTE: This address must be a static IP address. W-AirWave supports
IPv4 and IPv6 addresses.
Subnet Mask None Specify the subnet mask for the secondary network interface.
Table 16: Secondary Network Interface Fields and Default Values
Network Time Protocol (NTP) Settings
On the AMP Setup > Network page, locate the Network Time Protocol (NTP) section. The Network Time
Protocol is used to synchronize the time between W-AirWave and your network’s NTP server. NTP servers
synchronize with external reference time sources, such as satellites, radios, or modems.
Specifying NTP servers is optional. NTP servers synchronize the time on the W-AirWave server, not on individual access
points.
To disable NTP services, clear both the Primary and Secondary NTP server fields. Any problem related to
communication between W-AirWave and the NTP servers creates an entry in the event log. Table 17 describes
the settings and default values in more detail. For more information on ensuring that W-AirWave servers have
the correct time, please see http://support.ntp.org/bin/view/Servers/NTPPoolServers.