Users Guide

Setting Default Description
Primary ntp1.yourdomain.com Sets the IP address or DNS name for the primary NTP server.
Secondary ntp2.yourdomain.com Sets the IP address or DNS name for the secondary NTP server.
Table 17: AMP Setup > Network > Secondary Network Fields and Default Values
Static Routes
On the AMP Setup > Network page, locate the Static Routes area. This section displays network, subnet
mask, and gateway settings that you have defined elsewhere from a command-line interface.
This section does not enable you to configure new routes or remove existing routes.
What Next?
l Go to additional tabs in the AMP Setup section to continue additional setup configurations. The next section
describes W-AirWave roles.
l Complete the required configurations in this chapter before proceeding. Dell support remains available to
you for any phase of W-AirWave configuration.
Creating W-AirWave Users
W-AirWave installs with only one user—the admin, who is authorized to perform the following functions:
l Define additional users with varying levels of privilege, be it manage read/write or monitoring.
l Limit the viewable devices as well as the level of access a user has to the devices.
Each general user that you add must have a user name, a password, and a role. Use unique and meaningful user
names as they are recorded in the log files when you or other users make changes in W-AirWave.
User name and password are not required if you configure W-AirWave to use RADIUS, TACACS, or LDAP authentication.
You do not need to add individual users to the W-AirWave server if you use RADIUS, TACACS, or LDAP authentication.
The user role defines the user type, access level, and the top folder for that user. User roles are defined on the
AMP Setup > Roles page. Refer to the previous procedure in this chapter for additional information, "Creating
User Roles" on page 1.
The admin user can provide optional additional information about the user, including the user's real name, email
address, phone number, and so forth.
Perform the following steps to display, add, edit, or delete W-AirWave users of any privilege level. You must be an
admin user to complete these steps.
1. Go to the AMP Setup > Users page. This page displays all users currently configured in W-AirWave. Figure 14
illustrates the contents and layout of this page.
Figure 14:AMP Setup > Users Page Illustration
Dell Networking W-AirWave 8.2.4 | User Guide Configuring W-AirWave | 42