Users Guide

47 | Configuring W-AirWave Dell Networking W-AirWave 8.2.4 | User Guide
If Local is selected, then remote will be attempted if a user is not available. If Remote is selected, then the local
database is searched if remote authentication fails. The order of remote authentication is RADIUS first, followed
by TACACS, and finally LDAP.
Select Save if you are finished or follow the next procedure to configure RADIUS, TACACS+, and LDAP
Authentication options.
Configuring RADIUS Authentication and Authorization
For RADIUS capability, you must configure the IP/Hostname of the RADIUS server, the TCP port, and the server
shared secret. Perform these steps to configure RADIUS authentication:
1. Go to the AMP Setup > Authentication page. This page displays current status of RADIUS. Figure 17
illustrates this page.
Figure 17:AMP Setup > Authentication Page Illustration for RADIUS
2. Select No to disable or Yes to enable RADIUS authentication. If you select Yes, several new fields appear.
Complete the fields described in Table 20.
Field Default Description
Primary Server
Hostname/IP Address
N/A Enter the IP address or the hostname of the primary RADIUS server.
Primary Server Port
(1-65535)
1812 Enter the TCP port for the primary RADIUS server.
Primary Server Secret N/A Specify and confirm the primary shared secret for the primary RADIUS
server.
Confirm Primary
Server Secret
N/A Re-enter the primary server secret.
Secondary Server
Hostname/IP Address
N/A Enter the IP address or the hostname of the secondary RADIUS server.
Secondary Server Port
(1-65535)
1812 Enter the TCP port for the secondary RADIUS server.
Table 20: AMP Setup > Authentication Fields and Default Values for RADIUS Authentication