Users Guide

Setting Default Description
Owner Role None Displays the user role that uploaded the firmware file. This is
the role that has access to the file when an upgrade is
attempted.
Description None Displays a user-configurable text description of the firmware
file.
Server Protocol None Displays the file transfer protocol by which the firmware file
was obtained from the server. This can be FTP, TFTP, HTTP,
HTTPS. or SCP.
Use Group File
Server
None If enabled, displays the name of the file server supporting the
group.
Firmware
Filename
None Displays the name of the file that was uploaded to W-AirWave
and to be transferred to an AP when the file is used in an
upgrade.
Firmware MD5
Checksum
None Displays the MD5 checksum of the file after it was uploaded to
W-AirWave. The MD5 checksum is used to verify that the file
was uploaded to W-AirWave without issue. The checksum
should match the checksum of the file before it was uploaded.
Firmware File
Size
None Displays the size of the firmware file in bytes.
Firmware
Version
None Displays the firmware version number. This is a user-
configurable field.
HTML Filename None Supporting HTML, displays the name of the file that was
uploaded to W-AirWave and to be transferred to an AP when
the file is used in an upgrade.
HTML MD5
Checksum
None Supporting HTML, displays the MD5 checksum of the file after
it was uploaded to W-AirWave. The MD5 checksum is used to
verify that the file was uploaded to W-AirWave without issue.
The checksum should match the checksum of the file before it
was uploaded.
HTML File Size None Supporting HTML, displays the size of the file in bytes.
HTML Version None Supporting HTML, displays the version of HTML used for file
transfer.
Desired
Firmware File for
Specified Groups
None The firmware file is set as the desired firmware version on the
Groups > Firmware Files page of the specified groups. You
cannot delete a firmware file that is set as the desired
firmware version for a group.
Table 29: Device Setup > Upload Firmware & Files Fields and Default Values (Continued)
Loading Firmware Files onto W-AirWave
Perform the following steps to load a device firmware file onto W-AirWave:
1. Go to the Device Setup > Upload Firmware & Files page.
2. Select Add by the New Firmware File option. The Add Firmware File page appears. Figure 21 illustrates this
page.
Dell Networking W-AirWave 8.2.4 | User Guide Configuring W-AirWave | 56