Users Guide

61 | Configuring W-AirWave Dell Networking W-AirWave 8.2.4 | User Guide
SWAN Component Requirements
WLSE (Wireless LAN
Solution Engine)
l IP Address
l Login
ACS (Access Control
Server)
l IP Address
l Login
APs
l APs within WDS Group
Table 31: Cisco SWAN Architecture Components (Continued)
Initial WLSE Configuration
Use the following general procedures to configure and deploy a WLSE device in W-AirWave:
l "Adding an ACS Server for WLSE" on page 61
l "Enabling Rogue Alerts for Cisco WLSE" on page 61
l "Configuring WLSE to Communicate with APs" on page 61
l "Discovering Devices" on page 61
l "Managing Devices" on page 62
l "Inventory Reporting" on page 62
l "Defining Access" on page 62
l "Grouping" on page 62
Adding an ACS Server for WLSE
1. Go to the Devices > Discover > AAA Server page.
2. Select New from the drop-down list.
3. Enter the server name, server port (default 2002), user name, password, and a secret.
4. Select Save.
Enabling Rogue Alerts for Cisco WLSE
1. Go to the Faults > Network Wide Settings > Rogue AP Detection page.
2. Select the Enable.
3. Select Apply.
Additional information about rogue device detection is available in "Configuring Cisco WLSE Rogue Scanning" on
page 63.
Configuring WLSE to Communicate with APs
1. Go to the Device Setup > Discover page.
2. Configure SNMP Information.
3. Configure HTTP Information.
4. Configure Telnet/SSH Credentials
5. Configure HTTP ports for IOS access points.
6. Configure WLCCP credentials.
7. Configure AAA information.
Discovering Devices
The following three methods can be used to discover access points within WLSE: