Users Guide

65 | Configuring W-AirWave Dell Networking W-AirWave 8.2.4 | User Guide
Figure 24:AMP Setup > ACS Page Illustration
2. Select Add to create a new ACS server, or select a pencil icon to edit an existing server. To delete an ACS server,
select that server and select Delete. When selecting Add or Edit, the Details page appears.
3. Complete the settings on AMP Setup > ACS > Add/Edit Details. Table 33 describes these fields:
Field Default Description
IP/Hostname None Sets the DNS name or the IP address of the ACS Server.
Protocol HTTP Launches a drop-down menu specifying the protocol W-AirWave uses when it
polls the ACS server.
Port 2002 Sets the port through which W-AirWave communicates with the ACS. W-AirWave
generally communicates over port 2002.
Username None Sets the user name of the account W-AirWave uses to poll the ACS server.
Password None Sets the password of the account W-AirWave uses to poll the ACS server.
Polling Period 10 min Launches a drop-down menu that specifies how frequently W-AirWave polls the
ACS server for user name information.
Table 33: AMP Setup > ACS > Add/Edit Details Fields and Default Values
4. Select Add to finish creating the new ACS server, or Save to finish editing an existing ACS server.
5. The ACS server must have logging enabled for passed authentications. Enable the Log to CSV Passed
Authentications report option, as follows:
n Log in to the ACS server, select System Configuration, then in the Select frame, select Logging.
n Under Enable Logging, select CSV Passed Authentications. The default logging options include the
two columns W-AirWave requires: User-Name and Caller-ID.
What Next?
l Go to additional tabs in the AMP Setup section to continue additional setup configurations.
l Complete the required configurations in this chapter before proceeding. Dell support remains available to
you for any phase of W-AirWave installation.
Integrating NMS Servers
You can integrate W-AirWave with Network Management System (NMS) servers. Doing so enables W-AirWave to
forward SNMP traps to the NMS.
Add an NMS Server
AirWave communicates with the NMS server using the SNMPv1, SNMPv2c, or SNMPv3 protocol over Port 162.