Users Guide

77 | Configuring and Using Device Groups Dell Networking W-AirWave 8.2.4 | User Guide
Security, SSIDs, AAA Servers, Radio, Controller Config, Instant Config, and Cisco WLC Config. See
Figure 29.
The mouse-over list can vary based on a group's settings.
Figure 29:Pop-up When Hovering over Wrench Icon in the Groups > List Page
Basic Configuration Settings
Table 37 describes the available settings and default values in the Basic section of the Group > Basic page.
Setting Default Description
Name Defined
when first
adding the
group
Displays or changes the group name. As desired, use this field to set the
name to uniquely identify the group by location, vendor, department, or any
other identifier (such as Accounting APs, Cisco devices, 802.1x APs, and so
forth).
Missed SNMP
Poll Threshold
(1-100)
1 Sets the number of Up/Down SNMP polls that must be missed before W-
AirWave considers a device to be down. The number of SNMP retries and the
SNMP timeout of a poll can be set on the Device Setup > Communication
page.
Regulatory
Domain
United States Sets the regulatory domain in W-AirWave, limiting the selectable channels for
APs in the group.
Timezone AMP System
Time
Allows group configuration changes to be scheduled relative to the time zone
in which the devices are located. This setting is used for scheduling group-
level configuration changes.
Allow One-to-
One NAT
No Allows W-AirWave to talk to the devices on a different IP address than the one
configured on the device.
NOTE: If enabled, the LAN IP Address listed on the AP/Devices > Manage
configuration page under the Settings area is different than the IP Address
under the Device Communication area.
Audit
Configuration
on Devices
Yes Auditing and pushing of configuration to devices can be disabled on all the
devices in the group. Once disabled, all the devices in the groups will not be
counted towards mismatched devices.
Table 37: Basic Group Fields and Default Values