Users Guide

Setting Default Description
NTP Server
#1,2,3
None Sets the IP address of the NTP servers to be configured on the AP.
UTC Time
Zone
0 Sets the hour offset from UTC time to local time for the AP. Times displayed in W-
AirWave graphs and logs use the time set on the W-AirWave server.
Daylight
Saving Time
No Enables or disables the advanced daylight saving time settings in the Proxim
section of the Groups > Basic configuration page.
Table 45: HPE Aruba/OfficeConnect Switch Fields and Default Values
Aruba/Dell Networking W
To configure settings specific to Dell locate the Aruba/Dell Networking W section and adjust these settings as
required. Table 46 describes the settings and default values of this section of the Groups > Basic page.
Setting Default Description
SNMP Version 2c The version of SNMP used by W-AirWave to communicate to the AP.
Offload WMS
Database
No Configures commands previously documented in the Dell Networking W-
AirWave 8.2.4 Best Practices Guide. When enabled, this feature allows W-
AirWave to display historical information for WLAN switches.
Changing the setting to Yes pushes commands via SSH to all WLAN switches
in Monitor Only mode without rebooting the controller. The command can be
pushed to controllers in manage mode (also without rebooting the
controller) if the Allow WMS Offload setting on AMP Setup > General is
changed to Yes.
Dell Networking
W-Series GUI
Config
Yes This setting selects whether you'd like to configure your devices using the
Groups > Controller method (either global or group) or using Templates.
Manage local
configuration on
controllers
No Enables or disables the management of local configuration including audit,
push, and import operations.
Ignore Rogues
Discovered by
Remote APs
No Configures whether to turn off RAPIDS rogue classification and rogue
reporting for RAPs in this group.
Delete
Certificates On
Controller
No Specifies whether to delete the current certificates on an ArubaOScontroller.
Table 46: Aruba Fields and Default Values
Dell Instant
To specify the Dell Instant settings to be applied to this group, locate the Dell Instant settings section of the
Groups > Basic page and adjust these settings as desired. Table 47 describes the settings and default values.
Dell Networking W-AirWave 8.2.4 | User Guide Configuring and Using Device Groups | 82