Users Guide

83 | Configuring and Using Device Groups Dell Networking W-AirWave 8.2.4 | User Guide
Setting Default Description
Enable Instant GUI
Config
No Select this option to configure your Instant APs via the IGC feature on the
Groups > Instant Config pages of the W-AirWave WebUI, rather than via
Instant template configuration.
Configure AirWave
communication
settings:
No If the Enable Instant GUIConfig setting is set to No, you can use this option
to configure t6he primary (and optionally, secondary) W-AirWave server
settings on an Instant AP via template configuration.
Disable auto join
mode
No If you enable the Disable auto join mode setting, then Instant APs will not
automatically join a group of Instant APs in W-AirWave when that device
becomes active on the network.
HTTPStimeout 5
minutes
the HTTPS timeout for Instant devices is the period for which W-AirWave
waits for an Instant heartbeat message.
The Missed SNMPPoll Threshold in the Basic Settings section at the
top of the Groups > Basic page sets the number of Up/Down SNMP polls
that must be missed before W-AirWave considers a device to be down.
If, for example, a group of Instant APs your group settings has a Missed
SNMPPoll Threshold of 1, then an instant AP is considered to be down if
there is 1 missed heartbeat during this HTTPS timeout period, which could
be anywhere between 1-30 min.
CA Cert None Specify a CA certificate for the Instant virtual controller. The fields in this
drop down will populate when a certificate of type Intermediate CA or
Trusted CA is added in the Device Setup > Certificates page.
Server Cert None Specify a server certificate for the virtual controller. The fields in this drop
down will populate when a certificate of type Server Cert is added in the
Device Setup > Certificates page.
Captive Portal Cert None Specify a Captive portal certificate for the virtual controller. The fields in
this drop down will populate when a certificate of type Captive Portal
Cert is added in the Device Setup > Certificates page.
Captive Portal Logo None You can use W-AirWave to download a captive portal logo to your Instant
APs. Upload the image (which must be 16k bytes or less) on the Device
Setup > Upload page, then click the Captive Portal Logo drop down list on
the Groups > Basic page to select the image to send to the W-IAPs.
RadSec Server Cert None Specify a RadSec server certificate for the virtual controller. The fields in
this drop down will populate when a certificate of type Server Cert is
added in the Device Setup > Certificates page.
RadSec CA Cert None Specify a RadSec CA certificate for the virtual controller. The fields in this
drop down will populate when a certificate of type Intermediate CA or
Trusted CA is added in the Device Setup > Certificates page.
Table 47: Virtual Controller Certificate Fields and Default Values
Cisco IOS/Catalyst
Configure settings specific to Cisco IOS/Catalyst. Table 48 describes the settings and default values in this section
of the Groups > Basic page.