Users Guide

85 | Configuring and Using Device Groups Dell Networking W-AirWave 8.2.4 | User Guide
Setting Default Description
Secondary
DNS
server
Blank Sets the IP address of the Secondary DNS server.
Default
DNS
domains
Blank Sets the default DNS domain used by the AP.
HTTP
Server
Port
80 Sets this port as the HTTP server port on all Proxim APs in the group.
Country
Code
United
States
Configures AMP to derive its time settings based on the country of location, as specified in this
field.
Table 50: Proxim/Avaya Settings (Continued)
HP ProCurve
To configure HP ProCurve specific settings, locate the HP ProCurve section of the Groups > Basic page and
adjust these settings as required. The following table describes the settings and default values.
Setting Default Description
SNMP Version 2c Sets the version of SNMP used by W-AirWaveto communicate to the AP.
ProCurve
XL/ZWeSM CLI
Communication
Telnet Sets the protocol W-AirWave uses to communicate with ProCurve XLWeSM devices.
Selecting SSH will use the secure shell for command line (CLI) communication. Selecting
Telnet will send the data in clear text via telnet.
ControllerSNMP
Version
2c Specifies the version of SNMP used by W-AirWaveto communicate to the controller.
Table 51: HP ProCurve Settings
Symbol
To configure settings for Symbol controllers, , locate the Symbol section of the Groups > Basic page and adjust
these settings as required. The following table describes the settings and default values.
Setting Default Description
SNMP Version 2c Specifies the version of SNMP used by AWMS to communicate to the device.
Symbol Client
Inactivity Timeout
(3-600 min)
3 Sets the minutes of inactivity after which a client associated to a Symbol AP will be
considered "inactive." A lower value typically provides a more accurate
representation of current WLAN usage.
NOTE: For other APs, AWMS has more precise methods to determine when inactive
clients are no longer associated to an AP.
Symbol Controller
CLI
Communication
Telnet The connection type to support the command-line interface (CLI) connection. The
options are Telnet and secure shell (SSH). This is supported for WS5100, RFS4000,
RFS6000 and RFS7000 devices only.
Web Config
Interface
Yes Enables or disables the http/https configuration page for the Symbol 4131 devices.
Table 52: Symbol Settings