Users Guide

Juniper/3Com/Enterasys/Nortel/Trapeze
To configure SNMP settings for 3Com, Enterasys, Nortel, or Trapeze devices, locate the
Juniper/3Com/Enterasys/Nortel/Trapeze section of the Groups > Basic page and click the SNMP Version
drop-down list to define the version of SNMP to be supported. The default setting is SNMPv2c.
Universal Devices, Routers and Switches
To configure settings for universal devices on the network, including routers and switches that support both
wired and wireless networks,, locate the Juniper/3Com/Enterasys/Nortel/Trapeze section of the Groups >
Basic page and click the SNMP Version drop-down list to define the version of SNMP to be supported. The
default setting is SNMPv2c.
Automatic Authorization
To control the conditions by which devices are automatically authorized into this group, locate the Automatic
Authorization settings section of the Groups > Basic page and adjust these settings as required. Table 53
describes the settings and default values.
Setting Default Description
Add New Controllers
and Autonomous
Devices Location
Use
Global
Setting
Whether to auto authorize new controllers to the New Devices List, the
same Group/Folder as the discovering devices, the same Group/Folder as
the closest IP neighbor, and/or a specified auto-authorization group and
folder. The Current Global Setting set in AMP Setup > General is shown
below this field. Selecting a different option overrides the global setting.
Add New Thin APs
Location
Use
Global
Setting
Whether to auto authorize new thin APs to the New Devices List, the same
Group/Folder as the discovering devices, the same Group/Folder as the
closest IP neighbor, and/or a specified auto-authorization group and folder.
The Current Global Setting set in AMP Setup > General is shown below.
Selecting a different option overrides the global setting for this group.
Table 53: Automatic Authorization Fields and Default Values
1. To automate putting multiple devices in this group into Manage mode at once so that changes can be applied
and have the devices revert to Monitor-Only mode after the maintenance period is over, locate the
Maintenance Windows option and define a new AP Group Maintenance Window.
2. Select Save when the configurations of the Groups > Basic configuration page are complete to retain these
settings without pushing these settings to all devices in the group. Save is a good option if you intend to
make additional device changes in the group, and you want to wait until all configurations are complete
before you push all configurations at one time. Select Save and Apply to make the changes permanent, or
select Revert to discard all unapplied changes.
Adding and Configuring Group AAA Servers
Configure RADIUS servers on the Groups > AAA Servers page. Once defined on this page, the Groups >
Security and Groups > SSIDs menus appear in the navigation bar, allowing you to select and configure your
RADIUS servers.
If the Groups > AAA Servers page does not appear in the navigation bar, select the group from the Groups > List
page, select the Groups > Basic page, then choose the Show Device Settings for : All Devices option in the Group
Display Options section of the Groups > Basic page.
Dell Networking W-AirWave 8.2.4 | User Guide Configuring and Using Device Groups | 86