Users Guide

10 | Configuring OV3600 for Global Alcatel-Lucent
Infrastructure
OmniVista 3600 Air Manager 8.2.4 | Best Practices Guide
2. In the Additional OV3600 Services section, set Enable AMON Data Collection to Yes, and set Prefer
AMONvs SNMP Polling to Yes.
3. Click Save.
Figure 5: AMON Data Collection Setting in OV3600 Setup > General
switch Setup (Master And Local)
Enabling these commands on AOS-W versions prior to 6.0.1.0 can result in performance issues on the switch. If you are
running previous firmware versions such as AOS-W 6.0.0.0, you should upgrade to AOS-W 6.0.1 (to obtain RF utilization
metrics) or 6.1 (to obtain RF utilization and classified interferer information) before you enter this command.
The following commands are for AOS-W versions 6.3.1 and later. To get the commands for other versions of
AOS-W, refer to the Command-Line Interface Reference Guide for that version.
Use SSH to access the switch’s command-line interface, enter enable mode, and issue the following commands:
(switch-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(switch-Name) (config) # mgmt-server type ov3600 primary-server <OV3600-IP>
(switch-Name) (config) # mgmt-server profile <profile-name>
(switch-Name) (config) # write mem
You can add up to four <OV3600-IP> addresses.