Users Guide
Aruba AirMesh
Aruba AirMesh outdoor products running MeshOS 4.2 are supported for monitoring and software upgrades.
Device Validated up to
MSR1200 MeshOS 4.2
MSR2000 MeshOS 4.2
MSR4000 MeshOS 4.2
MST200 MeshOS 4.2
Table 4: Aruba MeshOS Device Support
Third-Party Vendor Devices
W-AirWave provides basic monitoring and, in some cases, management ofthe third-party vendor devices listed
below. The following section describes the features, and provides the list of supported devices and firmware
versions.
Monitoring
W-AirWave supports the following basic monitoring features for third party devices, unless specified otherwise:
l User monitoring data such as connection time, user name, SSID, and bandwidth
l Network monitoring data, including real-time and historical bandwidth and user count metrics
l Rogue detection and classification using W-AirWavecustomizable rules
l VisualRF heatmaps and user/rogue location
l Reports
l Triggers and alerts
Management
W-AirWave supports the following basic management features for third party devices, unless specified
otherwise:
l Basic configuration
l Firmware upgrades
l Controller and APdiscovery
Cisco
®
Devices
This section describes the Cisco devices and software versions supported in W-AirWave.
Cisco Autonomous APs running IOS
The following IOS AP product families are supported for monitoring, configuration, and software upgrades.
The firmware versions listed in the table below represents the latest firmware version verified as fully supported by W-
AirWave 8.2.4. Informal testing shows that W-AirWave supports devices running more recent versions of firmware, but
full support for these later versions is not guaranteed.
The following table describes the Cisco Autonomous APs supported for monitoring and management.
4 Dell Networking W-AirWave 8.2.4 | Supported Infrastructure Devices