Users Guide
Cisco Monitoring and Management
Model Validated up to
8510 Controller 7.4.121.0
3650 Switch 03.06.01E
3850 Switch 03.06.01E
4800 Switch (Pre-VxWorks) - Monitoring Only 8.65.2
Table 6: Cisco Wireless LAN Controllers and APs Support Matrix (Continued)
Support is not available for the following products:
l Mobility Services Engine
l 500 series APs
Cisco Switches
Cisco switches have the following additional support through W-AirWave:
l Automated discovery through SNMP
l Model & software version identification
l CDP neighbor information and extended port error stats
l 3750 stack information
l 3850 and 3650 configured as a switch
Hewlett Packard Enterprise Devices
The firmware versions for the HPE devices listed Table 7 represent the latest firmware version verified as fully
supported by W-AirWave 8.2. The devices inTable 7 are available within the VisualRF product catalog and can be
selected when setting up device-specific triggers and alerts. In addition, these devices can be set up as trap
receivers, and the SNMP traps can be seen on the System > Syslog & Traps page.
W-AirWave does not support MSM APs running in autonomous mode.
Informal testing shows that W-AirWave supports some devices running more recent versions of firmware, but
full support for these later versions is not guaranteed. For more information on configuring and managing and
HPE switches via W-AirWave, refer to the W-AirWave Switch Configuration Guide.
Model FirmWare Validated Up To
MSM310 and MSM310R 6.5.1.0
MSM313 and MSM313R 6.5.1.0
MSM317 6.5.1.0
MSM318 6.5.1.0
MSM320 and MSM320R 6.5.1.0
Table 7: HPE Device Support
Dell Networking W-AirWave 8.2.4 | Supported Infrastructure Devices 7