Deployment Guide

28 | DellNetworking W-Series Specific Capabilities in AirWave Dell Networking W-AirWave 7.7 | Best Practices Guide
Remote AP Monitoring
To monitor remote APs, follow these steps:
1. From the APs/Devices > List page, filter on the Remote Device column to find remote devices.
2. To view detailed information on the remote device, select the device name. The page illustrated in Figure 15 appears.
Figure 15 Remote AP Detail Page
3. You can also see if there are users plugged into the wired interfaces in the Connected Clients list below the Clients
and Usage graphs.
This feature is only available when the remote APs are in split tunnel and tunnel modes.
ARM and Channel Utilization Information
ARM statistics and Channel utilization are very powerful tools for diagnosing capacity and other issues in your WLAN.
1. Navigate to an APs/Devices > Monitor page for any of the following: Dell Networking W-AP105, W-AP92, W-
AP93, W-AP124, W-AP125, W-AP134, or W-AP135.
2. In the Radios table, select a radio link under the Name column for a radio.
3. The graphs default to Client and Usage. Select the drop down icon for each to change these to Radio Channel and
Channel Utilization.