Deployment Guide

46 | Increasing Location Accuracy Dell Networking W-AirWave 7.7 | Best Practices Guide
l Ensure that the firewall configuration for port 5050 (default port) supports bidirectional UDP communication
between the AirWave server's IP address and each access point's IP address.
Enable RTLS Service on the AirWave Server
To enable RTLS service on the AirWave server, follow these steps:
1. Navigate to AMP Setup > General and locate the Additional AMP Services section
2. Select Yes for the Enable RTLS Collector option.
3. A new section will automatically appear with the following settings:
l RTLS Port - the match controller default is 5050
l RTLS Username - This must match the SNMPv3 MMS username configured on the controller.
l RTLS Password - This must match the SNMPv3 MMS password configured on the controller.
Figure 30 RTLS Fields in AMP Setup> General
4. Click Save at the bottom of the page when you are done.
Enable RTLS on the Controller
RTLS can only be enabled on the master controller and it will automatically propagate to all local controllers.
SSH into master controller, enter enable mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z