Deployment Guide

(Controller-Name) (config) # ap system-profile <Thin-AP-Profile-Name>
(Controller-Name) (AP system profile default) # rtls-server ip-addr <IP of AirWave Server> port
5050 key <Controller-SNMPv3-MMS-Password>
(Controller-Name) (AP system profile default) # write mem
To validate exit configuration mode:
(Controller-Name) # show ap monitor debug status ip-addr <AP-IP-Address>
...
RTLS configuration
-------------------
Type Server IP Port Frequency Active
---- --------- ---- --------- ------
MMS 10.51.2.45 5070 120
Aeroscout N/A N/A N/A
RTLS 10.51.2.45 5050 60 *
Troubleshooting RTLS
You can use either the WebUI or CLI to ensure the RTLS service is running on your AirWave server.
Using the WebUI
In the AirWave WebUI, navigate to the System > Status page.
Scroll down through the Services list to locate the RTLS service, as shown below.
Figure 31 RTLS System Status
Using the CLI
Use SSH to access the command-line interface of your AirWave server, and issue the following commands:
[root@AMPServer]# daemons | grep RTLS
root 17859 12809 0 10:35 ? 00:00:00 Daemon::RTLS
Issue the logs and tail rtls commands to check the RTLS log file and verify that Tag chirps are making it to the
AirWave server.
[root@AMPServer]# logs
[root@AMPServer]# tail rtls
payload: 00147aaf01000020001a1ec02b3200000001000000137aae0100000c001a1ec02b320000001a1e82b322
590006ddff02
1224534900.588245 - got 96 bytes from 10.51.1.39 on port 5050
Mon Oct 20 13:35:00 2008: 1224534900.588338 - got 96 bytes from 10.51.1.39 on port 5050
payload: 0014c9c90100003c001a1ec050780000000200000013c9c70100000c001a1ec050780000000d54a7a280
540001ddff020013c9c80100000c001a1ec050780000000cdb8ae9a9000006c4ff02
1224534900.588245 - got 96 bytes from 10.51.1.39 on port 5050
Dell Networking W-AirWave 7.7 | Best Practices Guide Increasing Location Accuracy | 47