Users Guide

10 | Controller Configuration in AirWave Dell Networking W-AirWave 7.7 | Controller Configuration
Groups > Controller Config Page with Global Configuration Enabled
When Use Global Dell Networking W Configuration is enabled in the AMP Setup > General page, a focused sub-
menu page displays allowing you to edit all configured Dell Networking W AP groups with the following factors:
l Dell Networking W AP Groups must be defined from the Device Setup > Dell Networking W Configuration page
before they are visible on the Groups > Controller Config page.
l Use this page to select the Dell Networking W AP Groups that you want to push to controllers.
l Use this page to associate a device group to one or more Dell Networking W AP Groups.
l From this page, you can select other profiles that are defined on the controller.
Figure 3 Groups > Controller Config > Dell Networking W AP Groups page illustration (partial display)
Groups > Controller Config when Global Configuration is Disabled
If Use Global Dell Networking W Configuration in AMP Setup > General is set to No, the Groups > Controller
Config page can be used to manage two or more distinctive configuration strategies using the same tree navigation as
the Device Setup > Dell Networking W Configuration page. Each of the sections is explained in "Controller
Configuration Sections in the Tree View" on page 10.
Controller Configuration Sections in the Tree View
Whether you are using global or group configuration, the Dell Networking W Configuration tree view page supports
several sections, as follows:
l "Dell Networking W AP Groups Section" on page 11
l "AP Overrides Section" on page 11
l "WLANs Section" on page 12
l "Profiles Section" on page 13
l "Security Section" on page 13
l "Local Config Section" on page 14
l "Advanced Services Section" on page 14
Only Dell Networking W AP Groups, AP Overrides, and WLANs contain custom-created items in the navigation pane.
For the remainder of this document, the navigation Controller Config > refers to the tree view in Device Setup or
Groups tabs, depending on whether global or group configuration is enabled.