Users Guide

42 | Controller Configuration Reference Dell Networking W-AirWave 7.7 | Controller Configuration
Field Default Description
page and adjust these settings as desired.
Ethernet Interface 0
Link Profile
default
Sets the duplex mode and speed of AP’s Ethernet link for ethernet
interface 0. The configurable speed is dependent on the port type, and
you can define a separate Ethernet Interface profile for each Ethernet link.
Select the pencil icon next to this field to display the Profiles > AP >
Ethernet Link details page and adjust these settings as desired.
Ethernet Interface 1
Link Profile
default
Sets the duplex mode and speed of AP’s Ethernet link for ethernet
interface 1. The configurable speed is dependent on the port type, and
you can define a separate Ethernet Interface profile for each Ethernet link.
Select the pencil icon next to this field to display the Profiles > AP >
Ethernet Link details page and adjust these settings as desired.
AP System Profile default
Defines administrative options for the controller, including the IP
addresses of the local, backup, and master controllers, Real-time
Locating Systems (RTLS) server values and the number of consecutive
missed heartbeats on a GRE tunnel before an AP reboots traps.
This field is a drop-down menu with the following options:
l Non-integer RTLS Server Station Message Frequency
l Too-high RTLS Server Port
l Too-low AeroScout RTLS Server Port
l Too-low RTLS Server Port
Select the pencil icon next to this field to display the Profiles > AP >
System details page and adjust these settings as desired.
Regulatory Domain
Profile
default
Defines an AP’s country code and valid channels for both legacy and
high-throughput 802.11a and 802.11b/g radios.
Select the pencil icon next to this field to display the Profiles > AP >
Regulatory Domain page and adjust these settings as desired.
SNMP Profile default
Selects the SNMP profile to associate with this AP group. The drop-down
menu lists all SNMP profiles currently enabled in AirWave.
Select the pencil icon next to this field to display the Profiles > AP >
SNMP page and adjust these settings as desired.
VoIP Call
Admission Control
Profile
default
Voice Call Admission Control limits the number of active voice calls per
AP by load-balancing or ignoring excess call requests. This profile
enables active load balancing and call admission controls, and sets limits
for the numbers of simultaneous Session Initiated Protocol (SIP),
SpectraLink Voice Priority (SVP), Cisco Skinny Client Control Protocol
(SCCP), Vocera or New Office Environment (NOE) calls that can be
handled by a single radio.
Select the pencil icon next to this field to display the Profiles > AP >
Regulatory Domain page and adjust these settings as desired.
802.11g Traffic
Management
Profile
default
Specify the minimum percentage of available bandwidth to be allocated
to a specific SSID when there is congestion on the wireless network, and
sets the interval between bandwidth usage reports. This setting pertains
specifically to 802.11g.
802.11a Traffic
Management
Profile
default
Specify the minimum percentage of available bandwidth to be allocated
to a specific SSID when there is congestion on the wireless network, and
sets the interval between bandwidth usage reports. This setting pertains
specifically to 802.11a.