Service Manual

24 | AMP and Dell PowerConnect W-Series Integration Strategies Dell PowerConnect W-AirWave |Version 7.3
 wlsxFrameReceiveErrorRateExceeded
 wlsxFrameFragmentationRateExceeded
 wlsxFrameBandWidthRateExceeded
 wlsxFrameLowSpeedRateExceeded
 wlsxFrameNonUnicastRateExceeded
 wlsxChannelRateAnomaly
 wlsxNodeRateAnomalyAP
 wlsxNodeRateAnomalySta
 wlsxEAPRateAnomaly
 wlsxSignalAnomaly
 wlsxSequenceNumberAnomalyAP
 wlsxSequenceNumberAnomalySta
 wlsxApFloodAttack
 wlsxInvalidMacOUIAP
 wlsxInvalidMacOUISta
 wlsxStaRepeatWEPIVViolation
 wlsxStaWeakWEPIVViolation
 wlsxStaAssociatedToUnsecureAP
 wlsxStaUnAssociatedFromUnsecureAP
 wlsxAPImpersonation
 wlsxDisconnectStationAttackAP
 wlsxDisconnectStationAttackSta
ARM Traps
 AP Power Change
 AP Mode Change
 AP Channel Change
Ensuring That IDS & Auth Traps Display in AMP Using CLI
Validate your ArubaOS configuration by exiting the configure terminal mode and issue the following command:
(Controller-Name) # show snmp trap-list
If any of the traps below don't show as enabled enter configure terminal mode and issue the following
command:
(Controller-Name) (config) # snmp-server trap enable <TRAPS FROM LIST ABOVE>
(Controller-Name) (config) # write mem
Ensure the source IP of the traps match the IP that AMP utilizes to manage the controller, as shown in Figure 10.
Navigate to APs/Devices > Monitor to validate the IP address in the Device Info section.
NOTE: See Appendix A, “CLI ArubaOS & AMP Commands” on page37 for the full command that can be copied and pasted
directly into the ArubaOS CLI.