Service Manual

Dell PowerConnect W-AirWave | Best Practices Guide CLI ArubaOS & AMP Commands | 37
Appendix A
CLI ArubaOS & AMP Commands
Enable Channel Utilization Events Utilizing ArubaOS CLI (Local and
Master Controllers)
SSH into the controller, and enter “enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mgmt-server type amp primary-server <AMP IP>
(Controller-Name) (config) # write mem
Enable Stats With the ArubaOS CLI (Local Controller in Master Local
Environment)
SSH into the controller, and enter “enable” mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # wms general collect-stats enable
(Controller-Name) (config) # write mem
CAUTION: Enabling these commands on ArubaOS versions prior to 6.1 can result in performance issues on the controller.
NOTE: Do not use these commands if using AMP GUI.
CAUTION: Enabling these commands on ArubaOS versions prior to 6.1 can result in performance issues on the controller.