Users Guide

40 | Controller Configuration Reference Dell Networking W-AirWave 8.0 | Controller Configuration Guide
Field Default Description
Ethernet Interface
0 Link Profile
default
Sets the duplex mode and speed of AP’s Ethernet link for ethernet interface 0.
The configurable speed is dependent on the port type, and you can define a
separate Ethernet Interface profile for each Ethernet link.
Select the pencil icon next to this field to display the Profiles > AP > Ethernet
Link details page and adjust these settings as desired.
Ethernet Interface
1 Link Profile
default
Sets the duplex mode and speed of AP’s Ethernet link for ethernet interface 1.
The configurable speed is dependent on the port type, and you can define a
separate Ethernet Interface profile for each Ethernet link.
Select the pencil icon next to this field to display the Profiles > AP > Ethernet
Link details page and adjust these settings as desired.
AP System Profile default
Defines administrative options for the controller, including the IP addresses of
the local, backup, and master controllers, Real-Time Locating Systems (RTLS)
server values, and the number of consecutive missed heartbeats on a GRE
tunnel before an AP reboots traps.
This field is a drop-down menu with the following options:
l Non-integer RTLS Server Station Message Frequency
l Too-high RTLS Server Port
l Too-low AeroScout RTLS Server Port
l Too-low RTLS Server Port
Select the pencil icon next to this field to display the Profiles > AP > System
details page and adjust these settings as desired.
Regulatory
Domain Profile
default
Defines an AP’s country code and valid channels for both legacy and high-
throughput 802.11a and 802.11b/g radios.
Select the pencil icon next to this field to display the Profiles > AP > Regulatory
Domain page and adjust these settings as desired.
SNMP Profile default
Selects the SNMP profile to associate with this AP group. The drop-down menu
lists all SNMP profiles currently enabled in AirWave.
Select the pencil icon next to this field to display the Profiles > AP > SNMP page
and adjust these settings as desired.
VoIP Call
Admission Control
Profile
default
Voice Call Admission Control limits the number of active voice calls per AP by
load-balancing or ignoring excess call requests. This profile enables active load
balancing and call admission controls, and sets limits for the numbers of
simultaneous Session Initiated Protocol (SIP), SpectraLink Voice Priority (SVP),
Cisco Skinny Client Control Protocol (SCCP), Vocera or New Office
Environment (NOE) calls that can be handled by a single radio.
Select the pencil icon next to this field to display the Profiles > AP > Regulatory
Domain page and adjust these settings as desired.
802.11g Traffic
Management
Profile
default
Specify the minimum percentage of available bandwidth to be allocated to a
specific SSID when there is congestion on the wireless network, and sets the
interval between bandwidth usage reports. This setting pertains specifically to
802.11g.
Table 2: Dell Networking W Configuration > Dell Networking W AP Groups Details, Settings and Default
Values (Continued)