Users Guide

Setting Default Description
Rogue Scanning Yes
If enabled, Symbol access points with 3.9.2 or later firmware in the group will
passively scan for rogue access points at the specified interval. This rogue
scan will not break a user’s association to the network.
Rogue Scanning
Interval (5-480
min)
240
If Rogue Scanning is enabled, this setting controls the frequency with which
scans are conducted (in minutes). Frequent scans provide the greatest
security, but AP performance and throughput available to user devices may
be impacted modestly during a rogue scan.
Table 65: Groups > Radio > Symbol Fields and Default Values
8. Select Save when radio configurations as described above are complete, select Save and Apply to make the changes
permanent, or select Revert to discard all unapplied changes.
Cisco WLC Group Configuration
The Groups > Cisco WLC Config page consolidates the settings for Cisco WLC devices from all group pages. The
Groups > SSIDs subtab applies to all device types except for Cisco WLC, which have WLANs configured on the Cisco
WLC Config page. It is not recommended to have Symbol 4131 and Proxim APs in the same group as Cisco devices.
Also, it is recommended that users set device preferences to Only devices in this group. This topic describes how to
access and navigate the Groups > Cisco WLC Config page.
Accessing Cisco WLC Configuration
Go to the Cisco WLC Config page in one of these two ways:
1. In Groups > List, select a group that has been defined to support Cisco devices. The Cisco WLC Config option
appears in the subtabs.
2. In Groups > List, create a new group to support Cisco devices with these steps:
n Select Add from the Groups > List page to create a new group, enter a group name, and select Add.
n Once AirWave prompts you with the Groups > Basic page, ensure that you enable device-specific settings for
Cisco WLC.
n After you select Save or Save and Apply, the Groups > Cisco WLC Config subtab appears in the navigation
pane at the top in association with that group.
Navigating Cisco WLC Configuration
The navigation pane on the left side of the Groups > Cisco WLC Config page is expandable, and displays the Cisco
configurations supported and deployed. Figure 46 and Figure 47 illustrate this navigation pane.
You can pre-populate the group WLC settings from a controller in the same group by performing an import on the
controller’s Audit page.
Figure 46:Groups > Cisco WLC Config Page Illustration, collapsed view
Dell Networking W-AirWave 8.0 | User Guide Configuring and Using Device Groups | 104