Users Guide

l Wireless Protection Policies
l Web Auth
Figure 56 illustrates these components and this navigation:
Figure 56:Groups > Cisco WLC Config > Security Navigation Illustration
Configuring Management Settings for Cisco WLC Controllers
AirWave allows you to configure of SNMP and Syslog Server settings for Cisco WLC controllers. You can configure up
to four trap receivers on the Cisco WLC including the AMP IP that can be used in Global Groups. To define SNMP and
server settings, go to the Groups > Cisco WLC Config > Management page, illustrated in Figure 57.
Figure 57:Groups > Cisco WLC Config > Management Navigation Illustration
Configuring Group PTMP Settings
The Groups > PTMP configuration page configures Point-to-Multipoint (PTMP) for all subscriber and base stations in
the device group. Subscriber stations must be in the same group as all base stations with which they might connect.
Perform the following steps to configure these functions.
1. Go to the Groups > List page and select the group for which to define PTMP settings by selecting the group that
supports Proxim MP.11. Alternatively, select Add from the Groups > List page to create a new group.
2. Select the Groups >PTMP tab. Figure 58 illustrates this page.
Dell Networking W-AirWave 8.0 | User Guide Configuring and Using Device Groups | 110