Users Guide

141 | Discovering, Adding, and Managing Devices Dell Networking W-AirWave 8.0 | User Guide
Field Description
Configuration
l Good means all the settings on the AP agree with the settings AirWave wants them to
have.
l Mismatched means there is a configuration mismatch between what is on the AP and
what AirWave wants to push to the AP. The Mismatched link directs you to this specific
APs/Devices > Audit page where each mismatch is highlighted.
l Unknown means the device configuration has not yet been fetched (possible issue with
credentials).
l Verifying means that the device is fetching a configuration that will be compared to the
desired settings.
l Error indicates a problem with the device. This configuration is accompanied with a
description of the error.
Firmware
Displays the firmware version running on the AP.
Newer AirMesh APs include the new bootloader APBoot. AirWave helps to identify the new
AirMesh APs from the old SKUs by displaying the bootloader information here.
Licenses
(Appears for Dell
controllers)
Selecting this link opens a pop-up window that lists the built-in licenses as well as other
installed licenses for this controller. This also shows whether any license has expired.
Controller
(Appears for
APs)
Displays the controller for the associated AP device as a link. Select the link to display the
APs/Devices > Monitor page for that controller.
Mesh Gateway * Specifies the mesh AP acting as the wired connection to the network.
Mesh Mode*
Specifies whether the AP is a portal device or a mesh node. The portal device is connected to
the network over a wired connection. A node is a device downstream of the portal that uses
wireless connections to reach the portal device.
Mesh ID * The name of the mesh device.
Google Earth* Selecting the Google Earth icon opens the mesh network view in Google Earth.
Type Displays the make and model of the device.
Last Contacted
Displays the most recent time AirWave has polled the AP for information. The polling interval
can be set on the Groups > Basic page.
Uptime
Displays the amount of time since the AP has been rebooted. This is the amount of time the
AP reports and is not based on any connectivity with AirWave.
LAN MAC
Address
Displays the MAC address of the Ethernet interface on the device.
Serial Displays the serial number of the device.
Radio Serial Displays the serial number of the radios in the device. This field is not available for all APs.
Location Displays the SNMP location of the device.
Contact Displays the SNMP contact of the device.
Table 74: APs/Devices > Monitor > Device Info Fields and Default Values (Continued)