Users Guide

311 | Creating, Running, and Emailing Reports Dell Networking W-AirWave 8.0 | User Guide
Field Description
Operating System Displays the operating system for the device type, when known.
IP Address Displays the IP address of the rogue device when known.
SSID Displays the SSID for the rogue device when known.
Network Type Displays the network type on which the rogue was detected, when known.
Channel Displays the wireless RF channel on which the rogue device was detected.
WEP Displays WEP encryption usage when known.
RSSI
Displays Received Signal Strength (RSSI) information for radio signal strength when
known.
Signal Displays signal strength when known.
LAN MAC Address Displays the MAC address for the associated LAN when known.
LAN Vendor Displays LAN vendor information associated with the rogue device, when known.
Radio MAC Address Displays the MAC address for the radio device, when known.
Radio Vendor Displays the vendor information for the radio device when known.
Port Displays the router or switch port associated with the rogue device when known.
Last Seen Displays the last time in which the rogue device was seen on the network.
Total Discovering APs Displays the total number of APs that detected the rogue device.
Total Discovery Events Displays the total number of instances in which the rogue device was discovered.
Table 148: New Rogue Devices Report Fields (Continued)
Using the PCI Compliance Report
AirWave supports PCI requirements in accordance with the Payment Card Industry (PCI) Data Security Standard (DSS).
The PCI Compliance Report displays current PCI configurations and status as enabled on the network. Verify that
AirWave is enabled to monitor compliance with PCI requirements, as described in the "Enabling or Disabling PCI
Auditing" on page 75.
In addition to citing simple pass or fail status with regard to each PCI requirement, AirWave introduces very detailed
diagnostic information to recommend the specific action or actions required to achieve Pass status, when sufficient
information is available. Refer to the "Auditing PCI Compliance on the Network" on page 73 for information about
enabling PCI on the network. The configurations in that section enable or disable the contents of the PCI Compliance
Report that is viewable on the Reports > Generated page.
"PCI Compliance Report Illustration Example" on page 312 illustrates the fields and information in a PCI Compliance
Report.