Users Guide

Figure 24:AMP Setup > RADIUS > Add RADIUS Accounting Client Page Illustration
1. To specify the RADIUS authentication server or network, browse to the AMP Setup > RADIUS Accounting page,
select Add, illustrated in Figure 24, and provide the information in Table 24.
2. Complete the following fields:
Setting Default Description
IP/Network None
Specify the IP address for the authentication server if you only want to accept
packets from one device. To accept packets from an entire network enter the
IP/Netmask of the network (for example, 10.51.0.0/24).
Nickname None Sets a user-defined name for the authentication server.
Shared Secret
(Confirm)
None
Sets the Shared Secret that is used to establish communication between AirWave
and the RADIUS authentication server.
Table 24: AMP Setup > Radius Accounting Fields and Default Values for LDAP Authentication
Configuring TACACS+ Authentication
For TACACS+ capability, you must configure the IP/Hostname of the TACACS+ server, the TCP port, and the server
shared secret. This TACACS+ configuration is for AirWave users and does not affect APs or users logging into APs.
1. Go to the AMP Setup > Authentication page. This page displays current status of TACACS+. Figure 25 illustrates
this page when neither TACACS+, LDAP, nor RADIUS authentication is enabled in AirWave.
Dell Networking W-AirWave 8.0 | User Guide Configuring AirWave | 53