Users Guide
91 | Configuring and Using Device Groups Dell Networking W-AirWave 8.0 | User Guide
17. Select Save when the configurations of the Groups > Basic configuration page are complete to retain these settings
without pushing these settings to all devices in the group. Save is a good option if you intend to make additional
device changes in the group, and you want to wait until all configurations are complete before you push all
configurations at one time. Select Save and Apply to make the changes permanent, or select Revert to discard all
unapplied changes.
What Next?
l Continue to additional sections in this chapter to create new groups or to edit existing groups.
l Once general group-level configurations are complete, continue to later chapters in this document to add or edit
additional device-level configurations and to use several additional AirWave functions.
Adding and Configuring Group AAA Servers
Configure RADIUS servers on the Groups > AAA Servers page.
Once defined on this page, RADIUS servers are selectable in the drop-down menus on the Groups > Security and
Groups > SSIDs configuration pages. Perform these steps to create RADIUS servers.
TACACS+ servers are configurable only for Cisco WLC devices. Refer to "Configuring Cisco WLC Security Parameters
and Functions" on page 109.
1. Go to the Groups > List page and select the group for which to define AAA servers by selecting the group name.
The Monitor page appears.
2. Select the AAA Servers page. The AAA Servers page appears, enabling you to add a RADIUS server. Figure 41
illustrate this page for AAA RADIUS Servers:
Figure 41:Groups > AAA Servers Page Illustration
3. To add a RADIUS server or edit an existing server, select Add New RADIUS Server or the corresponding pencil
icon to edit an existing server. Table 53 describes the settings and default values of the Add/Edit page.
Setting Default Description
Hostname/IP
Address
None
Sets the IP Address or DNS name for RADIUS Server.
NOTE: IP Address is required for Proxim/ORiNOCO and Cisco Aironet IOS
APs.
Table 53:
Adding a RADIUS Server Fields and Default Values