Users Guide

Setting Default Description
Encryption Mode WPA2/PSK
WPA2 WPA
Compatibility Mode
Yes
Specify whether to enable WPA2 WPA Compatibility Mode.
WPA1 Cipher
(Cisco WLC Only)
TKIP
Specify the WPA1 Cipher. Values include AES, TKIP, and AES/TKIP.
NOTE: This drop down is only available if WPA2 WPA Compatibility Mode is
Yes.
Unicast Cipher
(Cisco Only)
AES/TKIP Specify the Unicast Cipher. Values include AES, TKIP, and AES/TKIP.
WPA Preshared
Key
(Alphanumeric)
None Enter an alphanumeric value for the preshared key.
Encryption Mode xSec
This indicates to use xSec encryption. No other configuration options are available.
Table 55: Groups > Security Encryption Mode settings (Continued)
3. Select Save to retain these security configurations for the group, select Save and Apply to make the changes
permanent, or select Revert to discard all unapplied changes.
4. Continue with additional security-related procedures in this document for additional RADIUS and SSID settings for
device groups, as required.
Configuring Group SSIDs and VLANs
The Groups > SSIDs configuration page allows you to create and edit SSIDs and VLANs that apply to a device group.
Perform these steps to create or edit VLANs and to set SSIDs.
WLANs that are supported from one or more Cisco WLC controllers can be configured on the Groups > Cisco WLC Config
page.
Figure 43 illustrates an example of the Groups > SSIDs page.
Figure 43:Groups > SSIDs Page Illustration
AirWave reports users by radio and by SSID. Graphs on the AP and controller monitoring pages display bandwidth in and
out based on SSID. AirWave reports can also be run and filtered by SSID. An option on the AMP Setup > General page
can age out inactive SSIDs and their associated graphical data.
Dell Networking W-AirWave 8.0 | User Guide Configuring and Using Device Groups | 96