Administrator Guide

l APs/Devices > Monitor > Radio Statistics: The Radio Statistics page for Dell Networking W-Instant devices
displays CPU Utilization, Channel Utilization, Bandwidth, Power, and MAC/Phy Error statistics.
l RAPIDS: Because Dell Networking W-Instant does not support mitigation or high-level rogue reporting, it does not
synchronize classification. All rogue devices are reported and stored in AirWave for evaluation based on high-level
rule sets. Dell Networking W-Instant currently does not match wireless BSSIDs to local MAC addresses within an
IAP's ARP table, and does not currently support IDS event notification.
l Reports: Dell Networking W-Instant Virtual Controllers appear as a separate device in the Device Inventory Report
and most other reports that list devices.
AirWave does not provide a Device Uptime report for Dell Networking W-Instant devices.
Other Available Features
Additional Instant features that are supported in AirWave include an editor for common variables, monitoring features,
CLI commands, and firmware image management.
l "Editing Variables" on page 9
l "Monitoring Features" on page 13
l "Running Commands" on page 14
l "Firmware Image Management" on page 15
l "Intrusion Detection System" on page 15
Editing Variables
AirWave includes support for editing variables on virtual controllers that have different values. Some common variables
include Name, LAN IP Address, Syslog Server, Timezone, Radius Servers, and RF Band Selection. AirWave also
supports additional generic variables that you can customize (such as adding a new WLAN). The defaults for all VC
variables can be changed from the Template page.
Perform the following steps to begin editing variables on virtual controllers.
1. On the APs/Devices > List page, select Modify Devices (wrench icon), and then select the check box beside the
virtual controllers that you want to edit.
Dell Networking W-Instant in W-AirWave 7.7 | Deployment Guide 9