Setup Guide

12 | Overview Dell Networking W-AirWave 7.7 | Getting Started Guide
Discovered devices use the default credentials configured on the Device Setup > Communication page for
each vendor-specific device. Refer to "How do I define credentials for devices that communicate with
AirWave?" on page 13 for more information.
4. Running a scan set.
a. Navigate to the Device Setup > Discover page and select the check boxes for each scan that you want to execute.
b. Click the Scan button located below the list of scan sets.
c. View the Start and Stop columns to see the status of the scan. Refresh the browser until both the Start and Stop
columns display date and time information. Newly discovered devices will display on the APs/Devices > New
page. These devices can then be added to your network.
Add Newly Discovered Devices to a Group
Perform the following steps to add a newly discovered device to a group.
1. Select the New Devices link in the header (top of the page). This opens the location where all newly discovered
devices are displayed. This is normally APs/Devices >New, though you may have specified a different location
while defining a scan set.
The information on this page includes the related controller (when known/applicable), the device type (including
vendor and model), the LAN MAC Address, the IP address, and the date/time of discovery. Refer to the following
image.
Figure 4 APs/Devices > New page
2. Select the check box beside the device or devices that you want to add.
3. Use the drop down menus to select the Group, Folder, and Dell AP Group to which the devices will be added. The
default group appears at the top of the Group list.