Setup Guide

Figure 11 Interface Monitoring Page for a Wired Device
An Interface Monitoring page is comprised of three sections: Interface Information, Usage and Interface Frame Counters
graphs, and Connected Clients.
Specifics of the interface are in the Interface Information section, as depicted in Figure 12.
Figure 12 Individual Interface Information Section
Bandwidth and other frame-counter information are displayed in the lower section in a tabbed graph, which is shown in
Figure 11 above.
Connected Clients, if any, are listed in a table below the interactive graphs as shown in Figure 13.
Figure 13 Connected Clients list in APs/Devices > Interface Monitoring for a selected interface
Monitoring with the RF Performance Page
The Home > RF Performance page provides graphs that enable you to identify clients with low SNR rates, speed, and
goodput. In the upper-left corner of this page, you can limit the information that displays by selecting a specific folder.
The Speed, Goodput, and Health graphs will only be populated with information from Dell devices that support AMON.
Dell Networking W-AirWave 7.7 | Getting Started Guide Monitoring Practices | 27