Setup Guide

You can find the AirWave event log on the System > Event Log page and at /var/log/amp_events from the AirWave
command line.
Perform the following steps to set up an external server
1. Navigate to the AMP Setup > General page and scroll down to the External Logging section.
2. Enter the IP address and port value of the syslog server.
3. Specify Yes for the "Include Event Log Messages" option.
4. Select an Event Log facility from the drop down menu. Typically, facility identifiers local0-local7 are available to
the admin to use as "custom" identifiers. (An exception is local5. On some systems, ftpd defaults to local5.)
Messages "tagged" with these identifiers can be sorted by the syslog server into separate log files. You set this up on the
syslog server in the /etc/syslog.conf file.
5. Specify Yes for the "Include Audit Log Messages" option.
6. Select an Audit Log facility from the drop down menu.
7. If desired, you can send a test message to the configured syslog server.
8. Select Save when you are done.
Dell Networking W-AirWave 7.7 | Getting Started Guide Monitoring Practices | 29