Reference Guide

Figure 28: RTLS Fields in AMP Setup > General
4. Select Save at the bottom of the page.
Enable RTLS on the Controller
NOTE: RTLS can only be enabled on the master controller and it will automatically propagate to all local controller s.
SSH into master controller, enter enable mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # ap system-profile <Thin-AP-Profile-Name>
(Controller-Name) (AP system profile default) # rtls-server ip-addr <IP of AMP Server> port
5050 key <Controller-SNMPv3-MMS-Password>
(Controller-Name) (AP system profile default) # write mem
To validate exit configuration mode:
(Controller-Name) # show ap monitor debug status ip-addr <AP-IP-Address>
...
RTLS configuration
-------------------
Type Server IP Port Frequency Active
---- --------- ---- --------- ------
MMS 10.51.2.45 5070 120
Aeroscout N/A N/A N/A
RTLS 10.51.2.45 5050 60 *
Dell PowerConnect W-AirWave 7.6 | Best Practices Guide Increasing Location Accuracy | 41