Setup Guide

Figure 16:ARM and Channel Utilization Graphs
See the Dell Networking W-AirWave 8.0 User Guide more information about the data that displays in the Radio
Statistics page for these devices.
VisualRF and Channel Utilization
1. Navigate to a floor plan by clicking on the thumbnail on a device’s APs/Devices > Monitor page or navigating to
VisualRF > Floor Plans page.
2. Select the Overlays menu.
Figure 17:Overlays
3. Select the Ch. Utilization overlay.
4. Select Current or Maximum (over last 24 hours).
l If Maximum is selected, then use the drop-down list to select total (default), receive (RX), transmit (TX), or
interference (Int.).
5. Select to view information for the current floor, the floor above, and/or the floor below.
6. Select a frequency of 5 GHz and/or 2.4 GHz.
Dell Networking W-AirWave 8.0 | Best Practices Guide Dell Networking W-Series Specific Capabilities in AirWave | 27