Setup Guide

To disable debugging, SSH into the controller, enter enable mode, and issue the following commands:
(Controller-Name) # show running-config | include logging level debugging
If there is output, then use the following commands to remove the debugging:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # no logging level debugging <module from above>
(Controller-Name) (config) # write mem
Restart WMS on Local Controllers
To ensure local controllers are populating rogue information properly, use SSH to access the command-line interface of
each local controller, enter enable mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # process restart wms
After executing the restart wms command in Dell Networking W-Series AOS, you will need to wait until the next
Rogue Poll Period on AirWave and execute a Poll Now operation for each local controller on the APs/Devices > List
page before rogue devices begin to appear in AirWave.
Configure AOS CLI when not Offloading WMS
To ensure proper event correlation for IDS events when WMS is not offloaded to AirWave, access the command line
interface of each controller (master and local), enter enable mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # ids management-profile
(Controller-Name) (config) # ids general-profile <name>
(Controller-Name) (config) # ids-events logs-and-traps
(Controller-Name) (config) # write mem
Copy and Paste to Enable Proper Traps with the AOS CLI
To ensure the proper traps are configured on Dell Networking W-Series controllers, copy and paste the following
command in config mode:
snmp-server trap enable wlsxNUserAuthenticationFailed
wlsxAdhocNetworkBridgeDetected
wlsxAdhocNetworkBridgeDetectedAP
wlsxAdhocNetworkBridgeDetectedSta
wlsxAdhocNetworkDetected
wlsxAdhocUsingValidSSID
wlsxAPChannelChange
wlsxApFloodAttack
wlsxAPImpersonation
wlsxAPModeChange
wlsxAPPowerChange
wlsxAPSpoofingDetected
wlsxBlockAckAttackDetected
wlsxChannelFrameErrorRateExceeded
wlsxChannelFrameFragmentationRateExceeded
wlsxChannelFrameRetryRateExceeded
wlsxChannelRateAnomaly
wlsxChopChopAttack
Dell Networking W-AirWave 8.0 | Best Practices Guide AOS and AirWave CLI Commands | 37