Setup Guide

47 | Increasing Location Accuracy Dell Networking W-AirWave 8.0 | Best Practices Guide
Figure 30:Typical Tag Deployment
Prerequisites
You will need the following information to monitor and manage your Dell Networking W-Series infrastructure.
l Ensure that the AirWave server is already monitoring Dell Networking W-Series infrastructure.
l Ensure that the WMS Offload process is complete.
l Ensure that the firewall configuration for port 5050 (default port) supports bidirectional UDP communication
between the AirWave server's IP address and each access point's IP address.
Enable RTLS Service on the AirWave Server
1. Navigate to AMP Setup > General and locate the Additional AMP Services section.
2. Select Yes for the Enable RTLS Collector option (see Figure 31 below).
3. A new section will automatically appear with the following settings:
l RTLS Port—The match controller default is 5050.
l RTLS Username—This must match the SNMPv3 MMS username configured on the controller.
l RTLS Password—This must match the SNMPv3 MMS password configured on the controller.
4. Click Save.