Setup Guide

Figure 31:RTLS Fields in AMP Setup> General
Enable RTLS on the Controller
RTLS can only be enabled on the master controller and it will automatically be propagated to all local controllers.
SSH into master controller, enter enable mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # ap system-profile <Thin-AP-Profile-Name>
(Controller-Name) (AP system profile default) # rtls-server ip-addr <IP of AirWave Server> port
5050 key <Controller-SNMPv3-MMS-Password>
(Controller-Name) (AP system profile default) # write mem
To validate exit configuration mode:
(Controller-Name) # show ap monitor debug status ip-addr <AP-IP-Address>
...
RTLS configuration
-------------------
Type Server IP Port Frequency Active
---- --------- ---- --------- ------
MMS 10.51.2.45 5070 120
Aeroscout N/A N/A N/A
RTLS 10.51.2.45 5050 60 *
Dell Networking W-AirWave 8.0 | Best Practices Guide Increasing Location Accuracy | 48