Setup Guide

8 | Configuring W-AirWave for Global W-Series Infrastructure Dell Networking W-AirWave 8.0 | Best Practices Guide
Setting Default Description
Primary
ntp1.yourdomain.com Sets the IP address or DNS name for the primary NTP server.
Secondary
ntp2.yourdomain.com Sets the IP address or DNS name for the secondary NTP server.
Table 1: AMP Setup> Network > Secondary Network Fields and Default Values
Enabling Support for Channel Utilization And Statistics
To enable support for channel utilization statistics, you must have the following versions:
l Dell Networking W-AirWave 7.6 or later
l Dell Networking W-Series AOS 6.0.1 or later
l Dell Networking W-Instant 3.3 or later
AOS 6.0.1 can report RF utilization metrics, while AOS 6.1 is necessary to also obtain classified interferer information.
W-AirWave Setup
1. Navigate to AMP Setup > General.
2. In the Additional AMP Services section, set Enable AMON Data Collection to Yes, and set Prefer AMONvs
SNMP Polling to Yes.
3. Click Save.
Figure 5:AMON Data Collection Setting in AMP Setup > General