Setup Guide

Controller Setup (Master And Local)
Enabling these commands on AOS versions prior to 6.0.1.0 can result in performance issues on the controller. If you are
running previous firmware versions such as AOS 6.0.0.0, you should upgrade to AOS 6.0.1 (to obtain RF utilization
metrics) or 6.1 (to obtain RF utilization and classified interferer information) before you enter this command.
The following commands are for AOS 6.4. To get the commands for other versions of AOS, refer to the Command-Line
Interface Reference Guide for that version.
Use SSH to access the controller’s command-line interface, enter enable mode, and issue the following commands:
(Controller-Name) # configure terminal
Enter Configuration commands, one per line. End with CNTL/Z
(Controller-Name) (config) # mgmt-server type amp primary-server <AMP-IP> profile <profile-name>
(Controller-Name) (config) # write mem
You can add up to four <AMP-IP> addresses.
Dell Networking W-AirWave 8.0 | Best Practices Guide Configuring W-AirWave for Global W-Series Infrastructure | 9