Service Manual

46 | Increasing Location Accuracy Dell PowerConnect W-AirWave 7.4 | Best Practices Guide
Figure 26 Typical Tag Deployment
Prerequisites
You will need the following information to monitor and manage your Dell PowerConnect W-Series
infrastructure.
 Ensure AMP server is already monitoring Dell PowerConnect W-Series infrastructure
 Ensure WMS Offload process is complete
 Ensure firewall configuration for port 5050 (default port) supports bidirectional UDP communication
between the AMP server's IP address and each access point's IP address
Enable RTLS service on the AMP server
To enable RTLS service on the AMP server, follow these steps:
1. Navigate to AMP Setup > General and locate the AMP Additional Services section
2. Select Yes to Enable RTLS Collector.
3. A new section will automatically appear with the following settings:
 RTLS Port - match controller default is 5050
 RTLS Username - match the SNMPv3 MMS username configured on controller
 RTLS Password - match the SNMPv3 MMS password configured on controller
Figure 27 RTLS Fields in AMP Setup > General
4. Select Save at the bottom of the page.