Users Guide
152 | Creating and Using Templates Dell PowerConnect W-AirWave 7.4 | User Guide
%ap_include_1% through %ap_include_10%
%channel%
%hostname%
%ip_address%
%ofdmpower%
The variable settings correspond to device-specific values on the APs/Devices > Manage configuration page for
the specific AP that is getting configured.
Viewing and Adding Templates
Perform these steps to display, add, or edit templates.
1. Go to the Groups > List page, and select a group for which to add or edit templates. This can be a new group,
created with the Add button, or you can edit an existing group by selecting the corresponding pencil icon. The
Groups > Basic page for that group appears. Additional information about adding and editing groups is
described in “Configuring and Using Device Groups in AirWave” on page69.
2. From the AirWave navigation pane, select Templates. The Templates page appears. Figure 112 illustrates the
Groups > Templates configuration page, and Table 89 describes the columns.
Figure 112 Groups > Templates Page Illustration for a Sample Device Group
NOTE: Changes made on the other Group pages (Radio, Security, VLANs, SSIDs, and so forth) are not applied to any APs that are
configured by templates.
Table 89 Groups > Templates Fields and Default Values
Setting Description
Notes When applicable, this section lists devices that are active on the network with no template available for the
respective firmware. Select the link from such a note to launch the Add Template configuration page for that
device.
Name Displays the template name.
Device Type Displays the template that applies to APs or devices of the specified type. If vendor (Any Model) is selected, the
template applies to all models from that vendor that do not have a version specific template defined. If there are
two templates that might apply to a device, the template with the most restrictions takes precedence.
Status Displays the status of the template.
Fetch Date Sets the date that the template was originally fetched from a device.