Users Guide

254 | Creating, Running, and Emailing Reports Dell PowerConnect W-AirWave 7.4 | User Guide
 Select Cancel to exit from the Add page.
Table 136 describes the configurable settings for the custom report to be created. Select any of the report names
to view additional information on that report type.
Table 136 Report Types and Scheduling Options Supported for Custom Reports
Report Type
Can by Run by
Time Period
Can be Run by
Group/Folder
Description
Using Custom Reports Yes Yes Summarizes devices based on which have exceeded a
defined percentage of their maximum bandwidth capacity.
Pulls data for AP radios or interfaces of universal devices
(ifSpeed value).
Using the Capacity
Planning Report
Yes Yes Tracks bandwidth capacity and consumption according to
thresholds for data throughput. This is a device-oriented
report.
Using the
Configuration Audit
Report
No Yes Provides a snapshot of the configuration of all specified
access points in AirWave, at report run time.
Using the Device
Summary Report
Yes Yes Summarizes user and bandwidth statistics and lists devices in
AirWave.
Using the Device
Uptime Report
Yes Yes Summarizes device uptime within defined groups or folders.
Using the IDS Events
Report
Yes Yes Summarizes IDS events; can be limited to a summary of a
certain number of events.
Using the Inventory
Report
No Yes Provides an audit of vendors, models and firmware versions
of devices in AirWave.
Using the Memory and
CPU Utilization Report
Yes Yes Summarizes usage for controllers for defined top number of
devices; can be run with or without per-CPU details and
details about device memory usage.
Using the Network
Usage Report
Yes Yes Summarizes bandwidth data and number of users.
Using the New Rogue
Devices Report
Yes No Shows new rogue devices by score, discovering AP, and MAC
address vendor.
Using the New Users
Report
Yes No Provides a summary list of new users, including username,
role, MAC address, discovering AP, and association time.
Using the PCI
Compliance Report
Yes Yes Provides a summary of network compliance with PCI
requirements, according to the PCI requirements enabled in
AirWave using the AMP Setup > PCI Compliance page.
Using the Port Usage
Report
Yes Yes Summarizes switch and port information across the network.
Generates information on the unused ports. Provides a
detailed list of all available switches and ports in the network.
Using the RADIUS
Authentication Issues
Report
Yes Yes Summarizes RADIUS authentication issues by controller and
by user, as well as a list of all issues.
Using the RF Health
Report
Yes Yes Tracks problematic radios, changes, errors, and interfering
devices.
Using the RF Health
Report
No Yes Identifies discrepancies between access point containment
status specified in AMP compared to containment status
identified by the controller at report run time.
Using the Client
Session Report
Yes Yes Summarizes user data by radio mode, SSID and VLAN, as well
as lists all sessions.