Users Guide

Dell PowerConnect W-AirWave 7.4 | User Guide Using VisualRF | 259
To enable VisualRF, follow these instructions while logged in as an administrator:
1. Go to AMP Setup > General.
2. Scroll down to the AMP Features section as shown in Figure 187. In the field Display VisualRF, select Yes.
Then select Save.
Figure 187 AMP Setup > General > AMP Features Page Illustration
3. After the VisualRF tab is visible, navigate to VisualRF > Setup.
4. In the Server Settings section, select Yes in the Enable VisualRF Engine field. Then select Save.
Figure 188 VisualRF > Setup > Server Settings Section
Basic QuickView Navigation
The top-level menus of VisualRF are split into two major categories: Network and Mesh, as shown in Figure 189
and Figure 190. Selecting these menus will cause relevant submenus and sections to display below:
Figure 189 Default VisualRF Top Level Menu - Network View
Figure 190 Default VisualRF Top Level Menu - Mesh View
Table 137 describes the top level icons and their functions on VisualRF.
Table 137 Top Level Icons and Descriptions
Operation Icon Description
Refresh Refresh the floor plan to see changes.
Open Site Tree Display the Network Tree View window on top of the floor plan.
Preferences Configure personal viewing preferences. The Preferences menu allows you
to configure user preferences (overlay types, grid lines, alerts, icon sizes).
See “Configuring QuickView Personal Preferences” on page 266 for more
details.
Help Launch the online help.
NOTE: This User Guide currently contains the most up-to-date help
information for the VisualRF interface.