Users Guide

58 | Configuring AMP Dell PowerConnect W-AirWave 7.4 | User Guide

Setting Up Device Types

On AMP Setup > Device Type Setup, you can define how the Device Type displayed for users on your network

is calculated from available data. The first matching property is used. These rules cannot be edited or deleted, but

only reordered or enabled.

You can change the priority order of rules by dragging and dropping rows, as shown in Figure 30.

Check or uncheck the checkbox under the Enabled column to turn device setup rules on or off.

Refer to “Monitoring and Supporting WLAN Clients” on page196 for more information on the Device Type

column that appears in Clients list tables.

Figure 30 AMP Setup > Device Type Setup Page Illustration

Configuring Cisco WLSE and WLSE Rogue Scanning

The Cisco Wireless LAN Solution Engine (WLSE) includes rogue scanning functions that AirWave supports.

This section contains the following topics and procedures, and several of these sections have additional sub-

procedures:

 Introduction to Cisco WLSE

 Configuring WLSE Initially in AirWave

 Configuring IOS APs for WDS Participation

 Configuring ACS for WDS Authentication

 Configuring Cisco WLSE Rogue Scanning

You must enter one or more CiscoWorks WLSE hosts to be polled for discovery of Cisco devices and rogue AP

information.

Introduction to Cisco WLSE

Cisco WLSE functions as an integral part of the Cisco Structured Wireless-Aware Network (SWAN)

architecture, which includes IOS Access Points, a Wireless Domain Service, an Access Control Server, and a

WLSE. In order for AirWave to obtain Rogue AP information from the WLSE, all SWAN components must be

properly configured. Table 34 describes these components.

Table 34 Cisco SWAN Architecture Components

SWAN Component Requirements

WDS (Wireless Domain

Services)

 WDS Name

 Primary and backup IP address for WDS devices (IOS AP or WLSM)

 WDS Credentials APs within WDS Group

NOTE: WDS can be either a WLSM or an IOS AP. WLSM (WDS) can control up to 250 access

points. AP (WDS) can control up to 30 access points.