Users Guide

Dell PowerConnect W-AirWave 7.4 | User Guide Configuring AMP | 59
Configuring WLSE Initially in AirWave
Use the following general procedures to configure and deploy a WLSE device in AirWave:
 Adding an ACS Server for WLSE
 Enabling Rogue Alerts for Cisco WLSE
 Configuring WLSE to Communicate with APs
 Discovering Devices
 Managing Devices
 Inventory Reporting
 Defining Access
 Grouping
 WDS Participation
 Primary or Secondary WDS
Adding an ACS Server for WLSE
1. Go to the Devices > Discover > AAA Server page.
2. Select New from the drop-down list.
3. Enter the Server Name, Server Port (default 2002), Username, Password, and Secret.
4. Select Save.
Enabling Rogue Alerts for Cisco WLSE
1. Go to the Faults > Network Wide Settings > Rogue AP Detection page.
2. Select the Enable.
3. Select Apply.
Additional information about rogue device detection is available in “Configuring Cisco WLSE Rogue Scanning”
on page62.
Configuring WLSE to Communicate with APs
1. Go to the Device Setup > Discover page.
2. Configure SNMP Information.
3. Configure HTTP Information.
4. Configure Telnet/SSH Credentials.
5. Configure HTTP ports for IOS access points.
6. Configure WLCCP credentials.
7. Configure AAA information.
WLSE (Wireless LAN
Solution Engine)
 IP Address
 Login
ACS (Access Control
Server)
 IP Address
 Login
APs  APs within WDS Group
Table 34 Cisco SWAN Architecture Components (Continued)
SWAN Component Requirements