Users Guide

Dell PowerConnect W-AirWave 7.4 | User Guide Configuring AMP | 67
Figure 34 AMP Setup > PCI Compliance Page Illustration
2. To enable, disable, or edit any category of PCI Compliance monitoring in AirWave, select the pencil icon next
to the category. The Default Credential Compliance page displays for the respective PCI standard.
3. Create changes as required. Specific credentials can be cited in the Forbidden Credentials section of any Edit
page to enforce PCI requirements in AirWave. Figure 35 shows one example.
Figure 35 Default Credential Compliance for PCI Requirements
4. Select Save.
5. To view and monitor PCI auditing on the network, use generated or daily reports. See Chapter 9, “Creating,
Running, and Emailing Reports” . In addition, you can view the real-time PCI auditing of any given device
online. Perform these steps:
a. Go to the APs/Devices > List page, select a specific device, and the Monitor page for that device displays.
The Monitor page displays a PCI Compliance subtab in the menu bar.
b. Select PCI Compliance to view complete PCI compliance auditing for that specific device.
What Next?
 Go to other tabs in the AMP Setup section to continue additional setup configurations.
 Complete the required configurations in this chapter before proceeding. AirWave support remains available to
you in any phase of AirWave installation.
Deploying WMS Offload
Overview of WMS Offload in AirWave
This section describes the Dell PowerConnect W Wireless LAN Management Server (WMS) offload
infrastructure. WMS Offload is supported with the following two requirements: